You can buy the Drawings of My CNC by pressing on the button below:

Buy CNC Machine V3 drawings - Price 18 dollars
(there is no shipping cost as the drawings are only sent via internet).

Before buying read the information below.

CNC V3 DRAWINGS - 18 DOLLARS ONLY

 

CNC V3 DRAWINGS (including catia V5 source files) - 23 DOLLARS ONLY

 

IMPORTANT NOTES:

- Only Drawings are sold no motors or any hardware is included in this offer (if you need bearings, you can send me an email for a quotation).

- the drawings are sold in order to help me develop more models and recover part of the cost.

-Drawings consist of  instruction manual (with few photos) and drawings files (Pdf + Dxf + IGES files).

- If after buying you need some particular photos to see some details not included in the manual, I will send them.

- There is no shipping via post mail. Only Email And / Or access to an internet resource to download the drawings.

- If there is any future improvement, buyers (identified by their email address) will automatically receive updates and revised drawings.

- PLEASE BE AWARE THAT ORIGINAL DESIGN IS MADE OF 75x10mm FLAT ALUMINUM BAR AND 50x50x5mm ALUMINUM ANGLES,
as a consequence, I can not guaranty that the system will work if it is wood made but I believe it can work even if you can not get the same rigidity as 10mm thick aluminum.

- The drawings can also be used as a starting base for the design of a slightly different machine (wood made or with different travel lenghts).

- Note that the original machine is made of expensive materials such as linear bearings (12 pieces for about $500), aluminum (which needs to be machined)...

- Final cost will depend on the motors and driver board you will use but don t except a low cost. It will also depend a lot on your ability to get the part made by yourself or not.

- I personally had the parts machined in a workshop and the fabrication cost is quite high...but the result is a semi-professional machine which is rigid and precise.

 

TECHNICAL INFORMATION:

- New update: ballscrew version! more than 4.2m/min maximum speed (travel becomes 600x500x40).

Also higher rigidity update.

- travels are about 800x500x40mm (can be extended)

- Motion is done with a M16 threaded rod (so 2mm per stepper revolution) or ballscrew (5mm per revolution).

- I recommend to use high torque steppers (>100 Oz.in).

- Machine is designed for the use of either Dremel tools or Makita style trimmers (70mm diameter).

- For the software to control your cnc, you can use Mach 2 ( http://www.artofcnc.ca/ ) ... it is a really good one!

I